| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Matt, 05' Outback Question http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=10559 |
Page 1 of 1 |
| Author: | Vlaude [ Thu Aug 28, 2008 11:25 am ] |
| Post subject: | Matt, 05' Outback Question |
Matt, I spoke with you about this in the past. I have a couple Outbacks, the oldest being from 05'. The 05' is actually my favorite of the two. But I have had a little water intrusion over the past couple years, but I decided it isn't at the drive (though might be wrong?) I can never seem to locate it for certain. I have the replacement kit that was sent out to me but I have yet to install it. I was told to make sure it wasn't leaking before I install it. I'm concerned about the longer bolts and the plastic stripping out... Should I just take this into Mariner Sails in Dallas (an authorized rep.)? Just curious, the yak was purchased in another state, but I typically go to Mariner Sails now when I need a part, etc... They seem to be pretty good with the assistance! Thanks! |
|
| Author: | mmiller [ Thu Aug 28, 2008 11:47 am ] |
| Post subject: | |
Certainly Mariner can handle the installation of the kit. Use a soapy water and internal air pressure test to find any leaks. |
|
| Author: | Superwave [ Thu Aug 28, 2008 3:27 pm ] |
| Post subject: | |
Vlaude, My leak was hard to find too (see my "Happy owner" post). Even though I was getting a couple gallons in just an hour on flat water the leak very hard to "find" on dry land. At first, I was sure it must be coming from somewhere else. I think the drivewell leak may open up as you are pedaling and stressing the area. Good luck. |
|
| Author: | Vlaude [ Thu Sep 04, 2008 1:06 pm ] |
| Post subject: | |
Thanks guys I think I'll just take it in... It's been going on for a year or so and would rather be safe than sorry I guess... I'm just a little concerned on whether to install the new locks if its ok now, from different stories I've heard about them stripping out. Oh well... I will say I am a happy Hobie owner and customer service has been great and the product even better... Thanks again, I'm gonna give Mariner Sails a call... |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|