| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| what is this conv post for? http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=13428 |
Page 1 of 1 |
| Author: | stupidjet [ Sun Aug 02, 2009 6:47 pm ] |
| Post subject: | what is this conv post for? |
what is this Hobie Ram Post Convertible used for? number 72023004 http://www.hobiecat.com/support/pdfs/ka ... _12-13.pdf does this post fit in scotty flush mount holes? |
|
| Author: | Jbernier [ Mon Aug 03, 2009 10:18 am ] |
| Post subject: | Re: what is this conv post for? |
yes - its to insert into a Scotty mount (flush or deck/side - either one) if you prefer a ram tube or other ram accessory, but already have a Scotty mount on your yak and don't want to add another mount, you can just use that ball set-up instead. |
|
| Author: | stupidjet [ Mon Aug 03, 2009 2:06 pm ] |
| Post subject: | Re: what is this conv post for? |
so then whats the screw on the bottom for? scotty products, you just push it in when the tab aligns and then twist it to lock. does this workt he same way? thanks for the help! |
|
| Author: | stupidjet [ Tue Aug 04, 2009 1:54 pm ] |
| Post subject: | Re: what is this conv post for? |
?? |
|
| Author: | mcattardo [ Wed Aug 05, 2009 5:14 am ] |
| Post subject: | Re: what is this conv post for? |
The conversion post doesn't look like it will twist and lock in requiring the screw to keep it in place. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|