| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| fitting click n go drive in locking cams http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=13896 |
Page 1 of 1 |
| Author: | mitch1 [ Thu Aug 20, 2009 9:05 am ] |
| Post subject: | fitting click n go drive in locking cams |
Sorry if this has been covered before ... will the drum shaft of a new click n go drive fit into the locking cam on an older kayak? I tried last night & it seems that the diameter of the drum shaft on the newer drive is a little thicker than the old. Thanks |
|
| Author: | mmiller [ Thu Aug 20, 2009 9:08 am ] |
| Post subject: | Re: fitting click n go drive in locking cams |
Should fit. The diameter is the same... over all length is the same. The ends are beveled rather than rounded now. Maybe off center? |
|
| Author: | mitch1 [ Thu Aug 20, 2009 9:15 am ] |
| Post subject: | Re: fitting click n go drive in locking cams |
thx for the fast response. I was trying to put the "new" drive (with ST fins that I installed) from my 2009 Sport into my wife's 2008 Sport for her to try. I thought I had read somewhere or been told by my dealer that it would fit. I'll play with it now. I wanted to make sure first before I forced anything. |
|
| Author: | mitch1 [ Thu Aug 20, 2009 12:35 pm ] |
| Post subject: | Re: fitting click n go drive in locking cams |
Thanks. I'll try it. When I tried to put the click n' go drive from my Sport (with ST fins that I installed) into my wife's older Sport for her to try out, it seemed like the shaft was a little bigger and I didnt want to force it. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|