| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Polyethylene hull compatability with Epoxy ? http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=17472 |
Page 1 of 1 |
| Author: | bobill14 [ Tue Nov 24, 2009 12:52 pm ] |
| Post subject: | Polyethylene hull compatability with Epoxy ? |
I have been using my Outback all summer without a problem and just love it....I fish a lot at night here in New England and have been reading about cracks/leaks developing in some hulls.This would ruin a good night out from shore so just want to know IF I develop a leak (and can get back to shore in one piece) can I repair it using fiberglass cloth (or mat) and West System Epoxy Resin which I have used for years to build/repair wooden boats???? I do seemto understand that GOOP bonds to polyethylene but does epoxy resin? Thanks..... Bill |
|
| Author: | Ranger908 [ Tue Nov 24, 2009 4:31 pm ] |
| Post subject: | Re: Polyethylene hull compatability with Epoxy ? |
I'm putting my money on Gorilla Tape. I keep a roll in the kayak. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|