| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| replacement Mirage spine/drum shaft question? http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=19874 |
Page 1 of 1 |
| Author: | Ictalurus [ Thu Jan 21, 2010 3:09 pm ] |
| Post subject: | replacement Mirage spine/drum shaft question? |
The spine on my steel-sprocketed Mirage Drive cracked at the main axle set screw. I ordered a replacement spine, but the drum shaft from my old drive doesn't seem to fit in the new spine. Do I need a new drum shaft to fit the new spine, or should I just get a bigger hammer?   I thought I'd ask here before I tried hammering stainless steel through plastic. Also, if I need a new drum shaft, will it work with my old drums? Thanks in advance. |
|
| Author: | mmiller [ Thu Jan 21, 2010 6:01 pm ] |
| Post subject: | Re: replacement Mirage spine/drum shaft question? |
Should be the same as your original spine. Bigger hammer I think. The new drum shafts are backwards compatible with spines, drums and hulls. |
|
| Author: | Ictalurus [ Fri Jan 22, 2010 7:17 am ] |
| Post subject: | Re: replacement Mirage spine/drum shaft question? |
Excellent. Thanks, Matt. The bigger hammer route is usually my go-to option, but I'm starting to learn from past mistakes.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|