| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| How do you remove the Outback "mast receiver"? http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=20726 |
Page 1 of 1 |
| Author: | caldvn [ Sun Feb 07, 2010 1:54 pm ] |
| Post subject: | How do you remove the Outback "mast receiver"? |
How do you remove the Outback "mast receiver"? The hole in front of the pedal to put the sail in. I purchased a used Outback that had a transducer installed, with a solid foam brick that has a hole that appears to have had the mast receiver slid in. I've tried counter clock wise, pull and it didn't budge. Don't really want to take pliers to until I can confirm that the right method to move it correctly to make some adjustments to the transducer. Thanks in advance. |
|
| Author: | mmiller [ Mon Feb 08, 2010 9:14 am ] |
| Post subject: | Re: How do you remove the Outback "mast receiver"? |
If current configuration... plastic part. There is a slot for a very long slotted screw driver in the bottom. Lefty-loosey... unscrew the fixture. Threads are at the top where it passes through the deck. The bottom rests on a small fixture molded into the hull. |
|
| Author: | rich_t [ Sat Mar 20, 2010 3:49 pm ] |
| Post subject: | Re: How do you remove the Outback "mast receiver"? |
In case you have not tried it yet, it is very tight. I had to have my strong son in law come over and do it for me (I had back surgery on 03/09/2010). It does come out though. Many thanks for asking the question. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|