Ouch!! That really sucks!!
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| fixing a hole in Pro Angler http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=22323 |
Page 1 of 1 |
| Author: | moodyoctopus [ Sun Mar 21, 2010 9:45 am ] |
| Post subject: | fixing a hole in Pro Angler |
any suggestion/recommendation/advice? big crack in one of the holes where the wheels' poles go. |
|
| Author: | troutbum [ Mon Mar 22, 2010 2:18 pm ] |
| Post subject: | Re: fixing a hole in Pro Angler |
Ouch!! That really sucks!!
|
|
| Author: | mmiller [ Mon Mar 22, 2010 3:09 pm ] |
| Post subject: | Re: fixing a hole in Pro Angler |
Quote: any suggestion/recommendation/advice? Contact your dealer. Supply them with photos if you can't get to the dealership. Cracks like this can be caused by improper cart use, but also from thin material coverage. |
|
| Author: | Roadrunner [ Mon Mar 22, 2010 6:47 pm ] |
| Post subject: | Re: fixing a hole in Pro Angler |
If it's not covered by warranty, you should be able to sleeve it from the inside of the boat (through a hatch opening) using 3M Scotchweld DP 8010 or Loctite 3030 -- both very strong and excellent bonders with Polyethylene. If all else fails you can plug it, seal it and go to a different style of cart. 
|
|
| Author: | sammy925 [ Wed Mar 24, 2010 8:59 am ] |
| Post subject: | Re: fixing a hole in Pro Angler |
I have not seen this product before but it looks very promising for us. TARTAN23455 in another thread stated once it is applied properly it will not come off. Quote: What you could do is get some 4" wide EternaBond tape and use it to cover the holes and cracks etc. I used it on my motor-home and if put on properly it WILL NOT come off. No matter what! Check it out!!http://www.eternabond.com/articles.asp?id=166 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|