Hobie Forums
http://www.hobie.com/au/en/forums/

Problem with Mirage drives
http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=24794		 Page 1 of 1
Author:  renbuild1 [ Sun May 16, 2010 10:12 am ]
Post subject:  Problem with Mirage drives
The shafts that connect the pedals to the actual drive can be adjusted for different length kayakers. This is done by pulling a pin that fixes the position of the arm to one of several holes on the drive.

My older Mirage has a spring loaded pin set in a u-shaped clip that holds the pedal shaft securely to the drive. I've lost a couple of these clips, so the pedal without the clip doesn't help with any of the work. I am looking for replacement pins.

The current parts catalogue shows a pedal adjustment assembly that looks different from what I have. Does anyone know if this new assembly with work on older models and similarly does anyone know if the older clips are still available and where to get them?

Thanks
Author:  mmiller [ Sun May 16, 2010 5:29 pm ]
Post subject:  Re: Problem with Mirage drives
The current system will work on an older drive. The original spring clips are no longer available. You can also use a simple bolt and nut if not doing a lot of adjusting. Some prefer that way as it makes a tighter connection.
Author:  renbuild1 [ Mon May 24, 2010 1:01 pm ]
Post subject:  Re: Problem with Mirage drives
Thanks, MM. I've used a shackle pin, but it fell out and it's nice to know that the new clips they sell will work ok with my old drives.
Author:  Roadrunner [ Mon May 24, 2010 10:37 pm ]
Post subject:  Re: Problem with Mirage drives
It makes a great improvement! Here's a 2000 Drive with its original pin arrangement:
Image

Here's the same Drive with the current "pedal adjustment" upgrade (note, "Drive Seal", far right, has also been added):
Image

You can also add a pair of pedal adjustment decals for a dollar.
Image

Much easier to use!! 8)
Author:  renbuild1 [ Tue May 25, 2010 4:30 am ]
Post subject:  Re: Problem with Mirage drives
Thanks, roadrunner. The pix are great.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/