Hobie Forums
http://www.hobie.com/au/en/forums/

Questions re: Holes and sealants.
http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=25931		 Page 1 of 1
Author:  RPL [ Fri Jun 04, 2010 1:24 pm ]
Post subject:  Questions re: Holes and sealants.
I'm getting ready to install an anchor trolley system on an Oasis. This will require drilling a few holes to accept two blocks and a couple of padeyes. I have the option of using either pop rivets or stainless steel screws with lock nuts. Whatever the case, is it a good idea to use some type of a sealant at the site of the holes? If so, what type works best? Thanks in advance for your answers and expertise!! - Roger 8)
Author:  KayakingBob [ Fri Jun 04, 2010 1:44 pm ]
Post subject:  Re: Questions re: Holes and sealants.
I use marine silicon caulking, but always use bolts and large washers inside.
Author:  RPL [ Wed Jun 09, 2010 12:26 pm ]
Post subject:  Re: Questions re: Holes and sealants.
Hey Thanks Bob! I did as you said and everything came out just fine. Now I can go out and find a great fishing spot on the bay and hopefully pull in an illusive redfish. :) - Roger
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/