| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| question on Mirage drive lanyard. http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=26020 |
Page 1 of 1 |
| Author: | DMacLeod [ Sun Jun 06, 2010 5:34 pm ] |
| Post subject: | question on Mirage drive lanyard. |
I just recieved a lanyard for my mirage drive and want to install. My drive is from 08 and doesn't have the triangle cut out like the one in the FAQ section above. Can I just drill a 1/4" hole and use a clevis ? Or is drilling something I shouldn't do? I bought the splash guard too and want to screw it on. Any suggestions on what SS screws to use? Thanks in advance for the help. |
|
| Author: | mmiller [ Mon Jun 07, 2010 11:45 am ] |
| Post subject: | Re: question on Mirage drive lanyard. |
You can drill. The accessory splash guard uses zip ties... sure you know. If you want to do the factory install: We use tapped holes. 2 each #8 x 5/8 screw. #10 washer. |
|
| Author: | DMacLeod [ Mon Jun 07, 2010 3:11 pm ] |
| Post subject: | Re: question on Mirage drive lanyard. |
Thanks Matt. I'll probably drill and tap. Thanks for the info on the drive leash too. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|