| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Broken Trolley Scupper Holes http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=32531 |
Page 1 of 1 |
| Author: | Bozzie [ Wed Oct 06, 2010 4:31 pm ] |
| Post subject: | Broken Trolley Scupper Holes |
I have just baught a secondhand blue Kona to set up as a fishing kayak. Both trolley scupper holes are cracked, as someone has stood in the kayak while it was on the trolley. I was thinking about putting a slieve around the scupper, or, perhaps just covering the top and bottom opening so it is totally sealed. Is there a prefered method of repairing this, or have I just wasted my money? Help please.... |
|
| Author: | Fly4v [ Wed Oct 06, 2010 9:19 pm ] |
| Post subject: | Re: Broken Trolley Scupper Holes |
I have read that you can split a length of PVC pipe and then cement the halves around the scupper tube inside the hull. Don't know what the best cement to use would be but I do know that you will need to sand the scupper to both clean and roughen the surface for the glue to bond. Hope this helps. |
|
| Author: | stringy [ Wed Oct 06, 2010 10:01 pm ] |
| Post subject: | Re: Broken Trolley Scupper Holes |
Bozzie, Roadrunner has reported successful repairs using Scotchweld DP8010. A search for his posts will yield a lot of info such as viewtopic.php?f=11&t=11245 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|