| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Revo rudder/steering cables http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=32900 |
Page 1 of 1 |
| Author: | nvydvrdude [ Thu Oct 28, 2010 4:40 am ] |
| Post subject: | Revo rudder/steering cables |
I searched the forum and didn't really find what i was looking for. In my wife's revo the cables are just flopping around in the back space of the yak. Has anybody secured them to the hull, if so how did you do it? Does anybody see a problem with doing this. I'm not wild about loose cables when we are underway and would like to secure them. Thanks for input, nvydvrdude |
|
| Author: | sammy925 [ Thu Oct 28, 2010 6:20 am ] |
| Post subject: | Re: Revo rudder/steering cables |
on the underside of the aft hatch were it is thru bolted on. On both sides there are factor installed clips that the tubes slip into. they probably just silpped out. Should be 3 slipped into the portside (1 rudder up haul and 2 for steering) and 1 slipped in the starboard clip for down haul. Thats how my AI is configured and I believe my Revo is the same. |
|
| Author: | FishIt [ Thu Oct 28, 2010 6:26 am ] |
| Post subject: | Re: Revo rudder/steering cables |
A small zip-tie will hold the tubes in the retainers..... |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|