| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| V1 chain assembly http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=35743 |
Page 1 of 1 |
| Author: | apctjb [ Mon May 23, 2011 5:15 pm ] |
| Post subject: | V1 chain assembly |
I have a V1 drive and the cable has pulled out from the fitting that attaches the cable to the chain. Was wondering if that is something that can be repaired (cable reinserted into fitting and brazed?). If not anyone know the best source to buy a new chain assembly? I hear they are very pricey. Thanks |
|
| Author: | mmiller [ Wed May 25, 2011 9:41 am ] |
| Post subject: | Re: V1 chain assembly |
No way to fix that. It is a hydraulic compression... once done... its done. You need a new one. |
|
| Author: | stobbo [ Wed May 25, 2011 9:23 pm ] |
| Post subject: | Re: V1 chain assembly |
Make sure you get the correct part - some of the cables differ from drive to drive... ! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|