| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hex wrench sizes for Mirage drive clamps http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=36443 |
Page 1 of 1 |
| Author: | Skadar [ Tue Jun 28, 2011 8:57 am ] |
| Post subject: | Hex wrench sizes for Mirage drive clamps |
Are Hobies metric or standard in general? In particular, what size hex wrench is use in the Mirage drive clamp (Click and Go) assembly. I noticed that one of my assemblies is a little loose. I can see hex nuts down through the holes, but I want to make sure I use the correct wrench size to avoid stripping when I tighten it up. Thanks! |
|
| Author: | EuroKayaker [ Wed Jun 29, 2011 2:34 am ] |
| Post subject: | Re: Hex wrench sizes for Mirage drive clamps |
requires 3/16" allen "ball" wrench |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|