Hobie Forums http://www.hobie.com/au/en/forums/ |
|
Twist N Stow conversion for E Volve motor http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=38182 |
Page 1 of 1 |
Author: | Lance [ Thu Sep 01, 2011 12:14 pm ] |
Post subject: | Twist N Stow conversion for E Volve motor |
I have a twist N stow rudder conversion for the E Volve motor. When I pull the up leaver the motor bangs on the rear deck my 2011 Oasis Kayak and as a result of this motion I have broken the slide tongue and groove plate that covers the cable to the motor. Where can I order a new plate and does anyone have a suggestion that would prevent this from happing again. Thanks, Lance from Portland, Maine |
Author: | Roadrunner [ Thu Sep 01, 2011 4:24 pm ] |
Post subject: | Re: Twist N Stow conversion for E Volve motor |
1. Control the flip up rate by using both handles at once. 2. Fashion a pad/cushion/carpet for the deck (held on by Velcro?). ![]() |
Author: | mmiller [ Thu Sep 01, 2011 4:43 pm ] |
Post subject: | Re: Twist N Stow conversion for E Volve motor |
Quote: Where can I order a new plate From your Hobie Dealer. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |