| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Cart Keeper Plug broken http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=38358 |
Page 1 of 1 |
| Author: | stk [ Thu Sep 08, 2011 9:55 am ] |
| Post subject: | Cart Keeper Plug broken |
Hmm....On my last trip back from the coast, when I pulled my Trax2 cart out, I noticed the cap had separated from pin. I can super-glue the pin back in place, but there is no longer a cord, so the cap will fall out if the cart is tilted. Is there a part number I can use to order a replacement? I don't see it in the catalog.  Many thanks, Steve |
|
| Author: | mmiller [ Thu Sep 08, 2011 10:36 am ] |
| Post subject: | Re: Cart Keeper Plug broken |
The cord is likely down in the cart frame tube. The shock cord is 1/8" diameter. |
|
| Author: | JDeee [ Thu Sep 08, 2011 5:40 pm ] |
| Post subject: | Re: Cart Keeper Plug broken |
I had the same problem but I lost the pin.  Is there a part number for the pin or the pin and cap?
|
|
| Author: | shesaManiYak [ Thu Sep 08, 2011 9:03 pm ] |
| Post subject: | Re: Cart Keeper Plug broken |
I had the same problem but the cord and pin were both down in the rod on the cart. Pulled them both out, 2-part epoxied them together. Good as new 
|
|
| Author: | JDeee [ Sun Sep 11, 2011 10:30 am ] |
| Post subject: | Re: Cart Keeper Plug broken |
Is there a part number for the pin or the pin and cap? I checkeddown the tube not there. |
|
| Author: | mmiller [ Mon Sep 12, 2011 9:39 am ] |
| Post subject: | Re: Cart Keeper Plug broken |
Not yet... but something we need, so: 80044151 PIN W/SHOCK CORD - CART KEEPER |
|
| Author: | Grampa Spey [ Tue Sep 13, 2011 10:05 am ] |
| Post subject: | Re: Is this available and at what cost? |
mmiller wrote: Not yet... but something we need, so:
80044151 PIN W/SHOCK CORD - CART KEEPER |
|
| Author: | tsquared [ Thu Sep 22, 2011 1:01 pm ] |
| Post subject: | Re: Cart Keeper Plug broken |
Good topic--my keeper just came apart too. I can fish the cord out of the tube--but then what? i notice there is a little slot adjacent to the metal pin hole in the black plastic piece. Do you jam the cord in there and push the metal pin on top of it, or epoxy it or ??? T2 |
|
| Author: | mmiller [ Fri Sep 23, 2011 9:27 am ] |
| Post subject: | Re: Cart Keeper Plug broken |
Yes, yes and yes. The cap captures the shock cord when you press it onto the pin. Epoxy is a good idea. |
|
| Author: | tsquared [ Fri Sep 23, 2011 7:45 pm ] |
| Post subject: | Re: Cart Keeper Plug broken |
Thanks Matt--I'll give that a whirl. T2 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|