Hobie Forums
http://www.hobie.com/au/en/forums/

Sealings to avoid water inlet via rudder lines
http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=38648		 Page 1 of 1
Author:  Kal-P-Dal [ Thu Sep 22, 2011 2:49 pm ]
Post subject:  Sealings to avoid water inlet via rudder lines
In my Adventure 2010 there were o-rings in the rudder line tubes to prevent water to enter this way. But the o-rings were of poor quality and were quickly worn out. My solution is bought at a bicycle shop and works quite good.

ImageImage
Image
Image
Image

You have to pull the tube out of the hull a bit and then pull over the rubber.

Thomas in Sweden
Author:  Tom Kirkman [ Thu Sep 22, 2011 2:57 pm ]
Post subject:  Re: Sealings to avoid water inlet via rudder lines
In case anyone wonders what to ask their bike shop for, those are the cable covers used on V-brake systems.
Author:  Kal-P-Dal [ Thu Sep 22, 2011 3:00 pm ]
Post subject:  Re: Sealings to avoid water inlet via rudder lines
Tom Kirkman wrote:
In case anyone wonders what to ask their bike shop for, those are the cable covers used on V-brake systems.


Correct. Sorry, forgot to mention that.

Thomas in Sweden
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/