I think Locktite should work fine -- give it a day to cure. You want ot use Locktite blue (in the red tube) in case you want to undo it later.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Back Fin coming loose http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=3902 |
Page 1 of 1 |
| Author: | Librarian [ Sun Jun 18, 2006 8:57 am ] |
| Post subject: | Back Fin coming loose |
Matt, The knurled tensioning nut on my back turbo flipper keeps loosening. Each time I go out it seems to loosen about 1/4 inch. If I forget to screw it tight again the fin comes off the shaft. Is there something I can do to keep it tight. I was told that Locktite is not good in salt water. |
|
| Author: | Roadrunner [ Sun Jun 18, 2006 6:47 pm ] |
| Post subject: | |
I think Locktite should work fine -- give it a day to cure. You want ot use Locktite blue (in the red tube) in case you want to undo it later.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|