| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Pinhole in hull (Floatcat) http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=44339 |
Page 1 of 1 |
| Author: | damfisher [ Wed Aug 08, 2012 8:29 am ] |
| Post subject: | Pinhole in hull (Floatcat) |
I recently was given a used Hobie floatcat 75. Upon inspecting it I noticed a small pinhole which is below the waterline (there was also an inch of water in that pontoon). It's so small I figured that a piece of tape might be a good temporary fix, but I wondered if anyone knew of a more permanent fix? I know this is the Kayak forum, but there is no Floatcat forum, and it's the same hull material. |
|
| Author: | Tom Kirkman [ Wed Aug 08, 2012 10:15 am ] |
| Post subject: | Re: Pinhole in hull (Floatcat) |
GOOP. Seriously, GOOP. It'll never leak another drop. |
|
| Author: | damfisher [ Wed Aug 08, 2012 11:02 am ] |
| Post subject: | Re: Pinhole in hull (Floatcat) |
Thanks, Tom! |
|
| Author: | MrGreen [ Fri Aug 10, 2012 6:47 am ] |
| Post subject: | Re: Pinhole in hull (Floatcat) |
Goop will work great and it's cheap the other option is the KC welder in the catalog |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|