Hobie Forums
http://www.hobie.com/au/en/forums/

How to install the Hobie Furling kit on a 2014 Oasis
http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=51416		 Page 1 of 1
Author:  dregsfan [ Tue May 27, 2014 3:27 pm ]
Post subject:  How to install the Hobie Furling kit on a 2014 Oasis
Not sure where to mount the fairlead. If I do like the instructions say, the pedal hits the line, so I won't be able to take a full stroke. Any ideas or photos of late model Oasis installs?
Author:  mmiller [ Tue May 27, 2014 3:39 pm ]
Post subject:  Re: How to install the Hobie Furling kit on a 2014 Oasis
Only options are to position more forward or reduce pedal stroke.
Author:  Roadrunner [ Tue May 27, 2014 10:50 pm ]
Post subject:  Re: How to install the Hobie Furling kit on a 2014 Oasis
The furler line should be routed around the cockpit. Position the fairlead forward enough to clear (or barely touch) the pedals when in the #7 position. The fairlead should split the angle where the line turns at the front corner -- it will be oriented approximately 45 degrees relative to the centerline. Lay it all out before you drill to make sure it looks good. 8)
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/