I've just discovered a crack in my Outback's hull and would appreciate any advice on what steps I can/should take to seal it and hopefully, keep it from expanding. It is a 2007 hull I received as replacement for a 2006 hull that had leakage issues in the miragedrive well. Photos are below.
The crack is open all the way through the plastic, and approximately 1.25" long. It's hard to tell from the photos, but the location is on the port side, at the rear of the top deck recessed area, where it drains into the rear deck. It's just forward of the rear port rod holder. As far as I can tell, accessing the crack from inside the hull is somewhere between a (censored) and impossible. All suggestions are appreciated. Thanks.
Thanks again.