| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mirage Drive Idler Pulley slack http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=54120 |
Page 1 of 1 |
| Author: | kinghong1970 [ Thu Mar 12, 2015 4:07 pm ] |
| Post subject: | Mirage Drive Idler Pulley slack |
hiya folks, i'm in middle of upgrading my V2 mirage drive to a GT and noticed that the idler pulley have a bit of slack... between 1/16" to 1/8" between the pulley and the frame. is this normal? do yours move front and back? am i missing a washer or something? seems like sand can get into the bearings from the front... thanks in advance, Al |
|
| Author: | mmiller [ Thu Mar 12, 2015 4:11 pm ] |
| Post subject: | Re: Mirage Drive Idler Pulley slack |
What vintage spine? |
|
| Author: | kinghong1970 [ Thu Mar 12, 2015 4:54 pm ] |
| Post subject: | Re: Mirage Drive Idler Pulley slack |
mmiller wrote: What vintage spine? well, my revolution is a 2014 model... any way of checking the mfg date on the spine? |
|
| Author: | mmiller [ Thu Mar 12, 2015 4:59 pm ] |
| Post subject: | Re: Mirage Drive Idler Pulley slack |
2014 would be as good as current in that specification. I just looked... I see about 1/16 or so gap. Engineers say "not to worry" |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|