Hobie Forums
http://www.hobie.com/au/en/forums/

Hobie Pro Angler Trailer Question
http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=58287		 Page 1 of 1
Author:  NewfoundlandLaw [ Tue Jul 12, 2016 10:32 am ]
Post subject:  Hobie Pro Angler Trailer Question
Hey All

I just purchased a new Hobie Pro Angler 12' and I am looking for a trailer that I can use for both my pro angler and my 12' Jon Boat. I have a good deal on a basic boat trailer, but I'm not sure it will be ok for a Hobie Pro Angler.

Here is the trailer I am interested in:

Image

The runners can be adjusted closer together to accommodate a narrow Kayak, so I don't see any potential issues. Do you guys and gals think this trailer would work for my new Pro Angler?
Author:  Dr.SteelheadCatcher [ Tue Jul 12, 2016 7:23 pm ]
Post subject:  Re: Hobie Pro Angler Trailer Question
The trailer looks fine but the "bunks" are unsuited for the PA's hull shape.
Also consider not inflating the tires to 40+ psi, but more on the order of 15 to 20 psi max, to keep the trailer from bouncing/hopping down the road due to the light load.

Hobie recommends using their supports, but IMHO, the 3" OD PVC parallel pipes work too, at a much lower cost.

The key is not too "cinch down too tight", the PA on the PVC pipes and the PVC has some "slop" in the attachment so they can move and contour to the hull shape.
This is achieved by using fender washers inside the PVC pipes,that you shape, to the inside pipe contour.

I use 1/4 x 20 bolts to secure the PVC pipes and 1/2" diameter holes in the PVC....if you use 1/4 x 20 Nylock nuts, they will not come loose.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/