Rectangle hatch.
(Tip...I used 1" #10 stainless steel screws)
Hook 5 on 1.5" ball and Geartrac.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Dialing in my new Camo Outback http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=61335 |
Page 1 of 1 |
| Author: | SHRED56 [ Thu Aug 17, 2017 4:14 pm ] |
| Post subject: | Dialing in my new Camo Outback |
Rectangle hatch. (Tip...I used 1" #10 stainless steel screws) Hook 5 on 1.5" ball and Geartrac.
|
|
| Author: | Defy [ Thu Aug 17, 2017 4:30 pm ] |
| Post subject: | Re: Dialing in my new Camo Outback |
Nice. I wonder if i can put the bigger hatch on my TI? Sent from my iPhone using Tapatalk |
|
| Author: | HStrech [ Thu Aug 17, 2017 4:44 pm ] |
| Post subject: | Re: Dialing in my new Camo Outback |
The deck on the TI is just about as wide as the Rectangular hatch, so the curvature where the deck transitions up toward the gunnel may present an issue in not allowing the hatch to sit flush on the deck. Hopefully some others chime in on this topic. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|