| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mirage drive stuck in place due to SS pin moving http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=63343 |
Page 1 of 1 |
| Author: | montaukfluker [ Wed Aug 01, 2018 6:24 am ] |
| Post subject: | Mirage drive stuck in place due to SS pin moving |
MIRAGE DRIVE PROBLEM. The stainless steel pin that hole the fins is riding out of place by 1/4 inch which keeps the pedals stuck in place when you need to pull them out. i used wiggling and force to pop it out. i tightened the screws at top of fin but the problem continued. i tap it back in place and its fine but coming in thru the surf so its a big problem. thank you |
|
| Author: | mmiller [ Wed Aug 01, 2018 10:41 am ] |
| Post subject: | Re: Mirage drive stuck in place due to SS pin moving |
What we would call the sprocket shaft? The screw you tightened is the allen set screw? Maybe not in a detent or the spine is cracked allowing the screw to come loose? Blue loc tite? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|