| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Need Hobie Paddle T-Handle? http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=64116 |
Page 1 of 1 |
| Author: | niswanger [ Fri Dec 28, 2018 9:06 pm ] |
| Post subject: | Need Hobie Paddle T-Handle? |
Doubt there is one for this situation. I believe this is one side of a 2-part Hobie Kayak paddle. Is there a T-Handle that will fit it? If not then I guess I'll try to make one from PVC. Thanks, |
|
| Author: | mmiller [ Wed Jan 09, 2019 5:35 pm ] |
| Post subject: | Re: Need Hobie Paddle T-Handle? |
Only available for the female half. |
|
| Author: | niswanger [ Fri Jan 11, 2019 7:11 am ] |
| Post subject: | Re: Need Hobie Paddle T-Handle? |
mmiller wrote: Only available for the female half. That's what I figured Matt, thank you. I used some 1" PVC that I turned out the inside slightly on a wood lathe to glue and fit snug on the paddle, then 3/4" piece to reduce it, again turning so the 3/4" fit into the 1" and then a 3/4" tee that I cut down so the tee wasn't so wide. finished it all with large heat shrink. 
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|