| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Broken crank arm http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=64939 |
Page 1 of 1 |
| Author: | clavadoc [ Thu Jun 13, 2019 1:55 pm ] |
| Post subject: | Broken crank arm |
I have a 2014 Revolution 16 with Mirage drive. I broke my 3rd crank arm just tooling around this am. I was 2 miles from shore but I made it back. Hobie and the dealer have been accommodating and replaced the broken part each time. Last time I was told the crank were now heavier but it lasted one season just like the previous two. BTW I am 155 lbs, not The Hulk. I believe the part is under-built and replacing yet again with the same defective product will produce the same result. Does anyone know of a sturdier after-market solution? Thanks |
|
| Author: | mmiller [ Thu Jun 13, 2019 4:16 pm ] |
| Post subject: | Re: Broken crank arm |
Hard to say if you actually got the newer thicker version... Show a photo of the end? So I can see wall thickness. |
|
| Author: | clavadoc [ Fri Jun 14, 2019 3:16 am ] |
| Post subject: | Re: Broken crank arm |
I would like to but it says on this forum that images cannot be uploaded from a computer. Any tips? |
|
| Author: | mmiller [ Fri Jun 14, 2019 8:53 am ] |
| Post subject: | Re: Broken crank arm |
FAQ - Using images and video in forum posts: https://www.hobie.com/forums/viewtopic.php?f=21&t=12574 |
|
| Author: | clavadoc [ Fri Jun 14, 2019 2:43 pm ] |
| Post subject: | Re: Broken crank arm |
I was not able to accomplish the image upload. You are not making this easy for a non-nerd. |
|
| Author: | mmiller [ Mon Jun 17, 2019 9:28 am ] |
| Post subject: | Re: Broken crank arm |
You could email it to me? [email protected] |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|