| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Can anyone identify what this mount is for? http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=67199 |
Page 1 of 1 |
| Author: | CKL [ Mon Aug 17, 2020 6:36 am ] |
| Post subject: | Can anyone identify what this mount is for? |
Hi - I just picked up an old '01 Mirage tandem - it has two square, flat surface mounting plates, ( either side of the transom behind the front seating position ), that look like a factory add on (same rivets). The base is black composite - but its inset with a square stainless steel plate ( 4 rivets) - with a knurled hole in the center that takes a screw ( sorry not sure of the screw size). Looks very much to be an adjustable mount - could be for a rod holder but since there is not other method of identification I don't know what i might mate to. Any help appreciated. Thanks! CKL |
|
| Author: | Dr.SteelheadCatcher [ Tue Aug 18, 2020 2:48 pm ] |
| Post subject: | Re: Can anyone identify what this mount is for? |
It sounds like the previous owner added it for mounting something......fish finder, rod holder, Sidekick AMA kit or ???? |
|
| Author: | CKL [ Mon Aug 24, 2020 1:44 pm ] |
| Post subject: | Re: Can anyone identify what this mount is for? |
Exactly - takes a #10-32 screw ... but I am at a loss as to what "screw down" rod holder etc. it might have been used for - nothing I have come across so far mounts this way . |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|