| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Handle too loose on Twist Seal hatch http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=67595 |
Page 1 of 1 |
| Author: | Angled [ Fri Nov 06, 2020 8:03 am ] |
| Post subject: | Handle too loose on Twist Seal hatch |
Problem on Hobie Revolution round twist & seal where the hatch handles on BOTH hatches (center and rear) are very loose so when carried upside down on car roof the handle just hangs down vertically. Is there a way to tighten that handle (the small roller ball & pin)? Hatches open and close fine but am afraid in future something might actually break or hatch open by itself as that handle blows around and shakes in the wind going 70 mph down the highway. I keep putting put tape over the handle when car topping but soon will run out of tape or patience to do that. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|