| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Arming CO2 Life Vests http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=67969 |
Page 1 of 1 |
| Author: | yaw_string [ Fri Mar 05, 2021 9:54 pm ] |
| Post subject: | Arming CO2 Life Vests |
For a special situation I am gonna use a non-automatic inflatable PFD. When I screw in the CO2 cylinder fairly tight there is never any pffft. It came non-attached from the vest when new. So do I take it that there is no actual cyl puncture until I pull the activator cord in an emergency? If so, it must take a hard pull. Of course I have waded thru all applicable instructions and videos. tks |
|
| Author: | stringy [ Sat Mar 06, 2021 1:30 pm ] |
| Post subject: | Re: Arming CO2 Life Vests |
Yes, the actuator punctures the cylinder. You need to make sure the cylinder is screwed tightly into the mechanism. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|