| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| drilling hole in hobie PA12 cassette plug http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=70566 |
Page 1 of 1 |
| Author: | raiderdude [ Sat Feb 04, 2023 10:32 am ] |
| Post subject: | drilling hole in hobie PA12 cassette plug |
What is best way to drill a hole thru the cassette plug to install watersnake TM? Should I spray in foam, and if so, how and when? |
|
| Author: | Dr.SteelheadCatcher [ Sat Feb 04, 2023 2:41 pm ] |
| Post subject: | Re: drilling hole in hobie PA12 cassette plug |
The material used in the cassette plug is quite soft and I would use a hole saw of the correct diameter. The hole saw should be the type that also has a pilot drill for centering the hole exactly where you want it and to prevent wandering of the cutting blade. I would think that spraying/inserting expandable foam is done after you have a tube/shaft in the cassette. Make sure to use a closed cell foam that won't absorb water. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|