I used the ram tubes but was wondering if anybody tried the scotty 444 compact flush mounts on the space before the molded in footwells start. Thanks.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| question about flush mounts on the front of the revo http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=8416 |
Page 1 of 1 |
| Author: | Fishing On Credit [ Thu Dec 06, 2007 6:19 pm ] |
| Post subject: | question about flush mounts on the front of the revo |
I used the ram tubes but was wondering if anybody tried the scotty 444 compact flush mounts on the space before the molded in footwells start. Thanks.
|
|
| Author: | sunjammers [ Thu Dec 06, 2007 9:59 pm ] |
| Post subject: | |
not sure what the 444 is but the one in the Hobie Catalog works great for me. 
|
|
| Author: | Fishing On Credit [ Fri Dec 07, 2007 5:40 am ] |
| Post subject: | |
thanks! those pics are gonna come in handy. the 444 is the compact round flush mount. |
|
| Author: | dueitt2s [ Tue Dec 11, 2007 6:12 am ] |
| Post subject: | |
|
|
| Author: | GetBent [ Tue Dec 11, 2007 12:34 pm ] |
| Post subject: | |
thanks foc and sunjammer for answering his question, the 444 will not fit. the back nut is about an 1/8in too big. i went ahead and got the mounting base you showed sun jammer. did the hard ware come with the mount by any chance? I may use rivets but stainless bolts and nylok nuts seem to be better. i got the rod extenders as well hopefully it works out like i hope. |
|
| Author: | sunjammers [ Tue Dec 11, 2007 3:28 pm ] |
| Post subject: | |
No, mounting hardware isn't included. I used sheet metal screw w/o backing nuts, never had had a problem with them pulling out. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|