| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Replacing Sprockets http://www.hobie.com/au/en/forums/viewtopic.php?f=11&t=9954 |
Page 1 of 1 |
| Author: | Blue Boat [ Mon Jul 07, 2008 6:28 am ] |
| Post subject: | Replacing Sprockets |
08 Revolution: Please provide detailed steps to replace plastic sprockets, single or both. Thanks |
|
| Author: | mmiller [ Mon Jul 07, 2008 5:02 pm ] |
| Post subject: | |
Lots of good information about adjustments etc in our FAQ: http://www.hobiecat.com/community/viewforum.php?f=21 The basics are... Mark the chain at the center sprocket tooth. Loosen the chain(s). Mark the drive axel on one end to help realign when replacing (runs length of the drive). Loosen the set screw in the center of the drive axel. Tap the axel aft or forward to allow the needed sprocket to be removed. Install new sprocket centering middle tooth on the chain once again. Tap axel back and spin to align set screw hole. Tighten set screw. Adjust chains. |
|
| Author: | kepnutz [ Mon Jul 07, 2008 5:08 pm ] |
| Post subject: | |
And there's more here if you need it.. http://www.hobiecat.com/community/viewtopic.php?t=7341 Kepnutz |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|