| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| ATR v3 paint/finish problem http://www.hobie.com/au/en/forums/viewtopic.php?f=125&t=59065 |
Page 1 of 1 |
| Author: | zaco77 [ Sat Sep 10, 2016 4:48 pm ] |
| Post subject: | ATR v3 paint/finish problem |
I bought my first Hobie SUP ATR v3 in June. I love this board, I use it in the rivers and bays where I live. I unfortunately have an issue with the paint/finish. I used suction cups for the deck rigging and the paint/finish lifted off the board. The shop I bought the board from contacted Hobie for warranty and Hobie said it is not covered. I am a bit confused as the suction cups I used specifically said for smooth fiberglass finish sufaces which is what the ATR series is. Has anyone experienced this? I sure wish I was given some heads up about this if it was a known issue. I really don't understand why the finish would be so fragile. |
|
| Author: | Bcastile [ Tue Sep 13, 2016 9:38 am ] |
| Post subject: | Re: ATR v3 paint/finish problem |
I have never seen suction cup damage before on a SUP. It is a painted surface though so a strong suction with a lot of force against it could damage or at least mark the paint I suppose. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|