Solved my 8:1 reeving problem. Thanks for everyone's help!
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Reeving Problem Solved http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=13562 |
Page 1 of 1 |
| Author: | OldSalt [ Fri Aug 07, 2009 4:58 pm ] |
| Post subject: | Reeving Problem Solved |
| Solved my 8:1 reeving problem. Thanks for everyone's help!
|
|
| Author: | RushMan [ Fri Aug 07, 2009 5:54 pm ] |
| Post subject: | Re: Bottom Diagram showing how to reeve Harken 8:1 Low Profile |
Found this on the Harken website 
|
|
| Author: | OldSalt [ Sat Aug 08, 2009 6:21 am ] |
| Post subject: | Re: Bottom Diagram showing how to reeve Harken 8:1 Low Profile |
The diagram you show has two triples and one single. Mine has two quads. This is exactly the rig I have: 8:1 Beachcat [img]wwwharken.com/images/main1b.gif[/img] This is Harken's page that shows this setup: harken.com/rigtips/mainsheet.php No where on Harken's (or anybody else's site) can I find reeving instructions for this particular setup. Paul |
|
| Author: | OldSalt [ Sat Aug 08, 2009 5:07 pm ] |
| Post subject: | Re: Reeving Problem Solved |
| Solved my 8:1 reeving problem. Thanks for everyone's help!
|
|
| Author: | gofastshawn [ Mon Aug 10, 2009 7:51 pm ] |
| Post subject: | Re: Reeving Problem Solved |
technically that is a 7:1 setup in the picture Paul. I run two 72mm quad carbo-air bblocks and the reeving is alittle different. I have tried several setups and by trial and error found one that doesnt interfere when hauled in tight.Let me get back to you when I get my camera out to where my boat is.I know the middle two sheeves are the last to be reeved, just to keep everything from binding sideways, will get u some pics. Shawn 82 H18 #8211 Div.3 |
|
| Author: | J_Eaton [ Tue Aug 11, 2009 1:37 pm ] |
| Post subject: | Re: Bottom Diagram showing how to reeve Harken 8:1 Low Profile |
RushMan wrote: Found this on the Harken website I'm confused, I guess you all (oldsalt & shawn) are making comments on this diagram? Two questions... how many sheaves are in the upper block? how many total sheaves are in the lower portion? |
|
| Author: | gofastshawn [ Tue Aug 11, 2009 8:55 pm ] |
| Post subject: | Re: Reeving Problem Solved |
I guess you have 8 ,my bad. I am used to 16 low profile sets. My 18 setup is two quads with a becket on the lower ratchetblock. shawn 82 H18 #8211 \div.3 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|