Hobie Forums
http://www.hobie.com/au/en/forums/

is all shock cord created equal.???.
http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=2227		 Page 1 of 1
Author:  hobie18retired [ Sat Aug 13, 2005 5:59 am ]
Post subject:  is all shock cord created equal.???.
I TRIED TO FOLLOW MATT'S ADVICE ON USING A 5 FT 6 IN PIECE OF SHOCK CORD FOR A "JIBSHEET TANGLE PREVENTER AND THE PIECE WAS ABOUT 2 FOOT SHORT. IS THERE A SPECIAL BRAND OF CORD. I USES A PIECE FROM WEST MARINE AND IT WOULD NOT REACH FROM STRICKER TO SPREADERS AND BACK DOWN
Author:  Hobie 18 #7877 [ Sat Aug 13, 2005 9:26 am ]
Post subject: 
Whoa there big guy! :shock: The shock cord should go from striker on lets say port hull, up to where the diamond wires attach at the turnbuckles on the mast (not the spreaders). Run the bungee from the aft side of the mast around the front of the mast and back towards the aft through the opposite turnbuckle and finally down to the striker bar on the starboard hull. The bungee should only go to the diamond wire turnbuckles, not the spreaders. Hope this helps. :D
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/