| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| How to install Easy Rite System on H18 http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=23663 |
Page 1 of 1 |
| Author: | sdmayer [ Wed Apr 21, 2010 6:29 pm ] |
| Post subject: | How to install Easy Rite System on H18 |
I'm relatively new to Hobie sailing, and feel stupid asking this question (as I know it's probably obvious to experienced cat sailors)...so here goes! I have a 1984 H18 and have spent the last few months trying to restore it a bit. I ordered the Stretch Righting System from Murrays last week, but can't follow the instructions really well. Does anyone have a short video to show me how they installed it on their H18? Or maybe some photos? I'm a visual guy, but the simple diagrams online haven't been helpful. Any help would be great. Thank you so much!! Scott |
|
| Author: | ncmbm [ Thu Apr 22, 2010 10:10 am ] |
| Post subject: | Re: How to install Easy Rite System on H18 |
If its what I think, you tie off one end on your rudder pins, run it up thru a ring attached where the dagger bungee ties off, across the front, thru the ring on the other side and back to the rudder pin again. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|