| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Dagger Well Seam Repair Suggestions http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=25076 |
Page 1 of 1 |
| Author: | BrianCT [ Sun May 23, 2010 12:46 pm ] |
| Post subject: | Dagger Well Seam Repair Suggestions |
Please see below - I have some separation at the joint between the hull and the daggerboard well (i.e., the small "lip" you see about 2" up inside the well from the bottom). This area isn't super accessible, so I was thinking of mixing up a blob of 5 minute epoxy and applying/smearing it to the lip with a stiff piece of cardboard (gravity should work in my favor). Thoughts? Last thing I want is a gushing leak when I take the old gal out for her maiden voyage.  
|
|
| Author: | RushMan [ Sun May 23, 2010 4:44 pm ] |
| Post subject: | Re: Dagger Well Seam Repair Suggestions |
There is a detailed post regarding this repair. http://www.hobiecat.com/community/viewtopic.php?f=13&t=22189 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|