| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Inspection Port Location? http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=37887 |
Page 1 of 1 |
| Author: | poolemarkw [ Tue Aug 23, 2011 10:24 am ] |
| Post subject: | Inspection Port Location? |
Hi Experts! I need to know if it is OK to add a 5" (curved) inspection port centered between the daggerboard trunk and rear crossbar. I found postings stating it's OK behind the rear crossbar, but nothing mentioning in front of it. Thanks, Mark |
|
| Author: | mmiller [ Tue Aug 23, 2011 10:26 am ] |
| Post subject: | Re: Inspection Port Location? |
Just that you would be sitting on it at times. That can crack the port or the surrounding area due to the hole. |
|
| Author: | poolemarkw [ Tue Aug 23, 2011 10:35 am ] |
| Post subject: | Re: Inspection Port Location? |
Excellent, thanks! |
|
| Author: | Tom Machette [ Wed Aug 24, 2011 8:12 pm ] |
| Post subject: | Re: Inspection Port Location? |
There also is a big foam block in that area, so you aren't going to get much room to look around in there. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|