| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Question on mast ball assembly http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=52070 |
Page 1 of 1 |
| Author: | hobie fun [ Mon Jul 07, 2014 7:01 am ] |
| Post subject: | Question on mast ball assembly |
Question, I just bought a Hobie 18. Boat is in good shape, but I noticed the mast ball assembly is not fully flush with the aluminum cross beam. The rivets are intact. When the mast is up there is some play in the ball assembly. It rocks a bit fore and aft (just a bit). Any thoughts on whether this needs to be repaired? |
|
| Author: | jim-doty [ Mon Jul 07, 2014 9:39 am ] |
| Post subject: | Re: Question on mast ball assembly |
This should definitely be repaired. Steve did a very nice write-up of how to do it here: viewtopic.php?f=13&t=42441&hilit=Mast+step |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|