I recently tried to assemble a second hand H18 .
There are stainless plates left in the bucket,I don't know where to put them onto the hull.
Is there anyone could help telling me the correct way to put them onto the hull?
Best regards
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| [help] Unknown stainless plates on H18 http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=53167 |
Page 1 of 1 |
| Author: | haya900r [ Sat Oct 18, 2014 2:57 am ] |
| Post subject: | [help] Unknown stainless plates on H18 |
I recently tried to assemble a second hand H18 . There are stainless plates left in the bucket,I don't know where to put them onto the hull. Is there anyone could help telling me the correct way to put them onto the hull? Best regards |
|
| Author: | moncasta [ Sat Oct 18, 2014 12:59 pm ] |
| Post subject: | Re: [help] Unknown stainless plates on H18 |
Those are wing support brackets. If you're using wings, then they go above the ouside crossbar castings under the head of the outer bolts. The legs from the wings rest on them and a pin goes through the hole. No wings, no need for brackets. |
|
| Author: | haya900r [ Sat Oct 18, 2014 5:51 pm ] |
| Post subject: | Re: [help] Unknown stainless plates on H18 |
Thank you for your information. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|