Started weak ended even worse but great times in between
Sent from my SM-G975U using Tapatalk
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Sad day http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=65367 |
Page 1 of 1 |
| Author: | Thiscowboysails [ Sun Aug 11, 2019 7:21 pm ] |
| Post subject: | Sad day |
Started weak ended even worse but great times in between Sent from my SM-G975U using Tapatalk |
|
| Author: | srm [ Mon Aug 12, 2019 9:14 am ] |
| Post subject: | Re: Sad day |
Looks like it would be worth trying to fix. Cut an access hole in the deck and glass the inside. Get some updated crossbar reinforcement plates and install at the rear crossbar. Also see if you can get some glass on the outside (it’s tough to do due to limited space under the lip. Pretty common failure mode for bosts of that vintage. sm |
|
| Author: | John Forbes [ Tue Aug 20, 2019 1:45 pm ] |
| Post subject: | Re: Sad day |
Great photos of both on and off the water. Thanks for sharing. Good luck with your repair. You’ll need to add the reinforcement plate kit to the beams and sidestay. |
|
| Author: | moncasta08 [ Fri Oct 25, 2019 2:59 pm ] |
| Post subject: | Re: Sad day |
The reinforcement kit was discontinued by Hobie. Look for some used ones. Consider not installing ports, but cutting holes and then glassing them closed, like a pumpkin lid. Installing ports creates another service point for the boat. Totally fixable though! |
|
| Author: | raisehull [ Fri Oct 25, 2019 6:52 pm ] |
| Post subject: | Re: Sad day |
kinda cool. sail# 113,800 sitting next to 390. |
|
| Author: | John Lunn [ Tue Oct 29, 2019 8:22 am ] |
| Post subject: | Re: Sad day |
Great pix, thanks for sharing. I too, have a dagger board like that! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|