| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Trapeze Rigging http://www.hobie.com/au/en/forums/viewtopic.php?f=13&t=7525 |
Page 1 of 1 |
| Author: | surprise3169 [ Mon Aug 06, 2007 9:22 pm ] |
| Post subject: | Trapeze Rigging |
Does anyone have a diagram on how to properly rig my trapeze lines? |
|
| Author: | ncmbm [ Tue Aug 07, 2007 7:56 am ] |
| Post subject: | |
what trap system are you using and do you run wings? |
|
| Author: | surprise3169 [ Wed Aug 08, 2007 5:47 am ] |
| Post subject: | |
I'm trying to set up just the standard adjustable trapeze rigging, and I do not have wings. |
|
| Author: | ncmbm [ Wed Aug 08, 2007 7:48 am ] |
| Post subject: | |
Its pretty simple. Tie one end to the bungee, install the jamb(which has 2 loops around it), go thru the eye on the trapwire and tie off on the trap handle or dogbone. The bungee holds the handle or dogbone tight to the trapwire eye. The jamb limits how low you trap. So, bungee on one end and handle on other. Jamb goes between trapwire eye and bungee tie off point, closer to tie off than handle. Hope this helps. If you have adjustable traps these instructions are not correct. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|