| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mirage drive fin fitment http://www.hobie.com/au/en/forums/viewtopic.php?f=138&t=64461 |
Page 1 of 1 |
| Author: | superbike1 [ Thu Mar 28, 2019 4:16 pm ] |
| Post subject: | Mirage drive fin fitment |
I have the 180 turbo fin version 2. Will other find fit on here or am I just going to be able to use md180 turbo fin? Sent from my Moto E (4) Plus using Tapatalk |
|
| Author: | superbike1 [ Thu Mar 28, 2019 4:28 pm ] |
| Post subject: | Re: Mirage drive fin fitment |
Sorry about spelling and gramatical errors. Fat fingers don't work well on phones. Sent from my Moto E (4) Plus using Tapatalk |
|
| Author: | Roadrunner [ Thu Mar 28, 2019 7:01 pm ] |
| Post subject: | Re: Mirage drive fin fitment |
You can switch to the shorter ST fins as long as you get the shorter masts to go with them. Simply unscrew the Turbo fins, unscrew the Turbo masts, install the ST masts then the fins. Be sure to use Loctite Blue (thread locker) so your masts stay put! 
|
|
| Author: | superbike1 [ Fri Mar 29, 2019 1:57 am ] |
| Post subject: | Re: Mirage drive fin fitment |
Roadrunner wrote: You can switch to the shorter ST fins as long as you get the shorter masts to go with them. Simply unscrew the Turbo fins, unscrew the Turbo masts, install the ST masts then the fins. Be sure to use Loctite Blue (thread locker) so your masts stay put! Thanks Roadrunner. That might get me a couple more inches of peddling clearance in shallow water before I have to stow the drive. I didn't need the speed anyway. I'm not going anywhere in a hurry anymore.Sent from my Moto E (4) Plus using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|