| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Scupper Hole Plastic Insert http://www.hobie.com/au/en/forums/viewtopic.php?f=138&t=64899 |
Page 1 of 1 |
| Author: | benqueso [ Sat Jun 08, 2019 7:10 pm ] |
| Post subject: | Scupper Hole Plastic Insert |
Is there a way to push these in further or are they glued in? One of mine sticks out farther than the other and slightly interferes with my Hobie cart going in. |
|
| Author: | mmiller [ Mon Jun 10, 2019 9:15 am ] |
| Post subject: | Re: Scupper Hole Plastic Insert |
They thread in... Usually, they stop when they get close to the top and aligned with the opening... wider width wise. |
|
| Author: | benqueso [ Mon Jun 10, 2019 5:28 pm ] |
| Post subject: | Re: Scupper Hole Plastic Insert |
Is there some type of tool I can buy to screw it in further? |
|
| Author: | mmiller [ Tue Jun 11, 2019 8:46 am ] |
| Post subject: | Re: Scupper Hole Plastic Insert |
The tool is custom... maybe a rectangular steel stock covered in thick tape for padding? |
|
| Author: | mwong005 [ Sat Jan 16, 2021 3:20 am ] |
| Post subject: | Re: Scupper Hole Plastic Insert |
My scupper inserts seem to be not aligned property as it prevents my plug in cart to completely go through the scupper. How do I fix this? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|