| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Transducer Installation Issues http://www.hobie.com/au/en/forums/viewtopic.php?f=138&t=65105 |
Page 1 of 1 |
| Author: | wyattearp [ Sun Jul 07, 2019 2:08 pm ] |
| Post subject: | Transducer Installation Issues |
Has anyone had issues installing the transducer through hull plug? I drilled the hole just above the scupper as shown in the video. However the plastic is very thick on one side of this hole and after about 1 turn of the nut clicks and jumps down a thread. I have tried several times and am certain it is not cross-threaded. It is a 2019 Compass. |
|
| Author: | felvic [ Mon Jul 08, 2019 10:31 pm ] |
| Post subject: | Re: Transducer Installation Issues |
wyattearp wrote: Has anyone had issues installing the transducer through hull plug? I drilled the hole just above the scupper as shown in the video. However the plastic is very thick on one side of this hole and after about 1 turn of the nut clicks and jumps down a thread. I have tried several times and am certain it is not cross-threaded. It is a 2019 Compass. It's a known problem, we had many Compass like that. The hulls often have a bump there, the only way is to sand down. You should rather use an electric sander believe me! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|