| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Line Routes and Foam Support Locations Inside Hull http://www.hobie.com/au/en/forums/viewtopic.php?f=138&t=69078 |
Page 1 of 1 |
| Author: | JustMe [ Sat Sep 18, 2021 7:56 am ] |
| Post subject: | Line Routes and Foam Support Locations Inside Hull |
Hello Everyone I purchased a used 2019 Compass and would like to make several upgrades or Mods. When I took it out for the maiden voyage the rudder would not drop. After reading here I found I needed to adjust the foam to not interfere and now the rudder works great Reading and looking at all the options I really want to make sure not to hit anything when drilling or screws be to long to chafe through a steering line. So does anyone have factory routing snd locations? Can I grind down the blob of plastic below the center hatch? When I install rectangular one the bucket will not fit for sure. Thanks for any snd all comments. Rob |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|