| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rudder cable placement/outrigger installation http://www.hobie.com/au/en/forums/viewtopic.php?f=138&t=70896 |
Page 1 of 1 |
| Author: | Creekfish94 [ Mon Jul 03, 2023 4:11 pm ] |
| Post subject: | Rudder cable placement/outrigger installation |
Is it safe to drill in the red or black highlighted areas on the linked picture? I’d like to install two railblaza starport hd mounts in this area to install yakgear outriggers but I’m not sure where the cables run through these areas. https://imgur.com/a/x6yF4ZK |
|
| Author: | plfinch [ Wed Jul 05, 2023 12:41 pm ] |
| Post subject: | Re: Rudder cable placement/outrigger installation |
Always best to get an inside view before drilling. Sometimes, even if there is no cable or hardware at the desired location, there will be a ridge or protrusion from the mold. I bought a cheap collapsible selfie stick for just this purpose. It has a separate remote control button to tell the phone to take photos. I maneuver the phone around inside the hull and use the remote button to snap photos or just record video. If the wife is around, I borrow her phone and use facetime between the two phones to view live video as I move my phone around in the hull. Peter |
|
| Author: | afishinado [ Thu Jul 06, 2023 6:57 am ] |
| Post subject: | Re: Rudder cable placement/outrigger installation |
Creekfish94 wrote: Is it safe to drill in the red or black highlighted areas on the linked picture? I’d like to install two railblaza starport hd mounts in this area to install yakgear outriggers but I’m not sure where the cables run through these areas. https://imgur.com/a/x6yF4ZK This is an "autopsy" video of an Outback which show the "innards" of it. Note the Compass has only cables on one side (the left) for steering. Hope this helps. https://www.youtube.com/watch?v=4HITJhSQ7ac |
|
| Author: | KungFowlChicken [ Thu Jul 13, 2023 12:46 pm ] |
| Post subject: | Re: Rudder cable placement/outrigger installation |
afishinado wrote: Creekfish94 wrote: Is it safe to drill in the red or black highlighted areas on the linked picture? I’d like to install two railblaza starport hd mounts in this area to install yakgear outriggers but I’m not sure where the cables run through these areas. https://imgur.com/a/x6yF4ZK This is an "autopsy" video of an Outback which show the "innards" of it. Note the Compass has only cables on one side (the left) for steering. Hope this helps. https://www.youtube.com/watch?v=4HITJhSQ7ac nothing to add except that i think your username is awesome. very creative. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|