The reason there is left & right rudder hardware is to keep the rudder toe in at an appropriate level. Put them on one way and you'll have several inches of toe in. Put them on the other and it'll be very very small, which is what you want.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| lower rudder castings http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=1009 |
Page 1 of 1 |
| Author: | gislergj [ Sun Jul 25, 2004 9:27 am ] |
| Post subject: | lower rudder castings |
i have been reading all the post for the past few months while i have been sanding and painting. I have always had a Hobie for as l can remember and in may got my first 16. Well my question is, are the lower rudder castings specific to the prot and starboard gudgeons? the assembly manuel says "identify the right rudder assembly ( green sticker) and the left one (Red sticker) they must not be reversed." And since this is close to a 30 year old boat best i can figure Sail #30523. the stickers are long gone. any help would be great thanks in advanced Greg |
|
| Author: | JaimeZXv.2 [ Fri Jul 30, 2004 9:24 pm ] |
| Post subject: | |
The reason there is left & right rudder hardware is to keep the rudder toe in at an appropriate level. Put them on one way and you'll have several inches of toe in. Put them on the other and it'll be very very small, which is what you want.
|
|
| Author: | Fleet_434_Where_Are_U [ Fri Jul 30, 2004 9:44 pm ] |
| Post subject: | |
LOWER castings on the 16 are the same the upper castings are not the same. 
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|