Hobie Forums
http://www.hobie.com/au/en/forums/

Rivit size
http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=13083		 Page 1 of 1
Author:  mmadge [ Wed Jul 15, 2009 12:37 pm ]
Post subject:  Rivit size
Matt M. what size rivit(or screw) is used to hold the sheave block for the jib travellor in the front corner casting?Also is there suppose to be a bushing inside the sheave block?
Author:  mmiller [ Wed Jul 15, 2009 4:42 pm ]
Post subject:  Re: Rivit size
No bushing... Rivet is 8011251 according to the catalog. That is a RIVET 6-16 PH HD-ALUM (RIVET 3/16 x 1-1/8 PH-AL)
Author:  mmadge [ Wed Jul 15, 2009 5:42 pm ]
Post subject:  Re: Rivit size
thank you :)
Author:  newsreader [ Mon Nov 30, 2009 12:45 am ]
Post subject:  Re: Rivit size
Can you please explain how to translate 6-16 into 3/16 x1-1/8 ?

Thanks.

mmiller wrote:
No bushing... Rivet is 8011251 according to the catalog. That is a RIVET 6-16 PH HD-ALUM (RIVET 3/16 x 1-1/8 PH-AL)
Author:  mmiller [ Mon Nov 30, 2009 2:26 pm ]
Post subject:  Re: Rivit size
I believe it relates to 1/32 of an inch, so (6) 6/32 = 3/16" Diameter and (16) 16/32 = 1/2" Grip length.
Author:  newsreader [ Mon Nov 30, 2009 6:17 pm ]
Post subject:  Re: Rivit size
Thanks.
mmiller wrote:
I believe it relates to 1/32 of an inch, so (6) 6/32 = 3/16" Diameter and (16) 16/32 = 1/2" Grip length.
Author:  Tom King [ Fri Dec 04, 2009 4:34 pm ]
Post subject:  Re: Rivit size
first number is diameter in 32nds of an inch
second number is length in 16ths

Must make sense to somebody, but I always had to stop and figure
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/